If your iPhone or iPod Touch is no longer new and fresh out of the box, you might have noticed that the fit for accessories that you plug into dock connector becomes a bit loose over time (this is also the case for the iGPS360 module).
Today's post is a tip and trick to tighten up your iGPS360 module (and whatever other accessories or 30-pin USB cables you have). This seems to work very well.
Get a razor blade edge/corner or any other pointed thin and sharp blade edge, like one of those small utility knives or a Stanley blade.
On the dock connector on the module (or any other accessory), you can see a metal cover (see the photo above). The cover has eight slits in it (four on the top and four on bottom; not counting the two outer ones on the bottom). These eight slits create four metal tabs in the metal.
Over time when you plug the iGPS360 module (or any other accessory accessory) a lot in and out of your iPhone or iPod Touch, these tabs get pushed in and the female dock connector on your iPhone/iPod Touch also becomes a bit looser. As such the press fit of the module into the iPhone/iPod becomes looser.
In order to tighten the connection up again, stick the knife edge/point carefully a little bit under each of those four tabs and lift them up a tiny bit, see the above photo. Don't do it to much otherwise it is going to be really hard to get the module/acessory back into your iPhone/iPod. And just as a general warning, be careful no to break those tabs.
This trick will make the connection (very) tight again. Just make sure not to over-do it or break those tabs. You only need to move them back up a tiny bit. Don't make it too tight either. If it seems too tight, very carefully slide the accessory back into your iPhone/iPod very slowly, wiggling it slowly left and right until it is fully seated.
I have performed this trick on one of my older iGPS360 modules and my oldest 2G iPhone (which was a bit loose) and I have a nice and tight fit again now.
If this works for you, post your results :-)
Want an
module?
Wish to become a distributor of the iGPS360 module?
Please send us an email at distributors@orangegadgets.com
Sunday, October 18, 2009
iGPS360 Tip and Trick
Subscribe to:
Post Comments (Atom)
4 comments:
woho... it workss dude!!! thanks for the info
very cool stuff
I had thought about doing this too but never attempted it. I bought a dock extender cable instead. Works great too as you can position the gps module in a better location than where your phone is.
Have you ever considered designing a custom USB interface that would allow the iGPS360 to work off a laptop or netbook PC?
Post a Comment